3 die cutting stations and 1 sheeting station

-- 3 die cutting stations and 1 sheeting station.

-- Independent registration on each die cutting and sheeting station that has a maximum lineal registration adjustment of +/- 3/16". The registry adjustment knob also has a position indicator.

-- Thru hardened steel removable anvil rolls in all the die cutting and sheeting stations. The die cutting stations have 3.5" diameter anvil rolls and the sheeting station has 4" diameter anvil roll. Thru hardened steel provides longer life and prevents marking from metal to metal die cutting.

-- Thru hardened steel support rolls for all die cutting and sheeting stations to allow for easy undercutting. A support roll also helps prevent deflection and prolongs the life of the anvil rolls and dies.

-- Standard 1" ID bearing blocks (other sizes are available) with 1/4 turn style for front side installation, hold-down rollers that bear directly on the die bearers, bearer wipers and die pressure adjusting units.

-- 18" maximum die cut repeat with an optional 24" die cut repeat which allows for the greatest die cutting and sheeting versatility.

-- 24" roll diameter waste wind-up, which consist of a small idler, an adjustable belt driven capstan and take up roll.

-- Exit pacing with pneumatically actuated nip roll, silicone rubber covered with 2" diameter bearings for rigidity. Exit pacing also includes an Exit Pacing Control Panel located at the Master Control Panel with nip "ON/OFF", nip pressure gauge and regulator knob.

-- 30" roll diameter rewind.

-- 3" diameter rewind shafts with air operated core holders.

-- Rewind Control Panel, which is located in the Master Control Panel. The "Core" switch that supplies air pressure to expand the core holder leaves, the "Clutch" switch supplies the air pressure indicated in the tension gauge to the clutch and the "Regulator" knob that regulates the air pressure supplied to the clutch, thus changing the rewind tension.

-- *Optional motor driven rewinds are available.