|
|
|
|
-- The 30"
roll diameter unwind is standard on the
310. A 40" roll diameter unwind with
roll lift is standard on the 313.
3" diameter unwind shafts with air-operated
coreholders. The "ON/OFF"
switch supplies air pressure to expand the coreholder leaves. The expansion
of the leaves traps the core when unwinding the stock.
-- Unwind Control Panel located at the top of the front panel on the unwind module. It contains the core "ON/OFF" switch, the unwind tension "ON/OFF" switch, the unwind tensions dial, the stop tension dial and the "JOG", "STOP" and "E-STOP" buttons. -- "UNWIND" tension control that works in conjunction with the follower arm to maintain constant tension as the stock roll reduces in size. This is attained through an electronically controlled unwind brake.-- "STOP" tension control to keep stock roll from coasting and slacking the web when you stop the press. -- Follow Arm/End-of-Roll Switch that automatically shuts off the press before the stock rolls runs out of material.-- Splicing platform located close to the unwind and makes quick work of roll changes and minimizes waste of time and materials. This platform is positioned waist high to allow the operator to easily perform the splicing operation. -- The Electronic Edge Guide System is a standard feature, which automatically compensates for imperfect or telescoped stock rolls to keep the web at a set position in the press. As a result, make-ready is easier and faster. This also aids side-to-side registry, while increasing production speeds.-- In-feed pacing module with pneumatically actuated nip roll, electronic controlled hysteresis brake infeed pacing roll, silicone rubber covered with 2" diameter bearings for rigidity. -- In-Feed Nip Control Panel which contains the "JOG", "RUN", IDLE", "STOP", "IMPRESSION" and "EMERGENCY" buttons, the nip "ON/OFF" switch, the nip pressure regulator and pressure gauge.-- The Power Tower Light indicates the press has power and is ready to run. |
|
